Hoshizaki KM-1900SWH/3 Manuel d'utilisateur télécharger pdf (Page 35)

22)Movethecontrolswitchtothe"WASH"position.

23) Replace the front panel in its correct position.

24) Turn on the power supply to rinse off the cleaning solution.

25) Turn off the power supply after 5 minutes.

26) Remove the front panel and the insulation panel.

27) Remove the cap located on the front bottom part of the ice dropping hole. Drain the

water tank. Replace the cap and the insulation panel in their correct positions.

Note:Donotreplacetheinsulationpanelwhenyouproceedto"2.Sanitizing

Procedure."

28) Repeat steps 16 through 27 three more times to rinse thoroughly.

Note:Ifyoudonotsanitizetheicemaker,gotostep9in"2.SanitizingProcedure."

2. Sanitizing Procedure - Following Cleaning Procedure

1)Dilute3.5.oz.(104mlor7tbs)ofa5.25%sodiumhypochloritesolution(chlorine

bleach) with 7 gal. (26 l) of warm water.

2) Pour the sanitizing solution into the water tank.

3) Replace the insulation panel and the front panel in their correct positions.

Note:Makesurethatthecontrolswitchisinthe"WASH"positionandthecleaningvalve

is open.

4) Turn on the power supply to start the sanitizing process.

5) Turn off the power supply after 15 minutes.

6) Remove the front panel and the insulation panel.

7) Remove the cap located on the front bottom part of the ice dropping hole. Drain the

water tank. Replace the cap and the insulation panel in their correct positions.

8)Repeatsteps16through27in"1.CleaningProcedure"twotimestorinsethoroughly.

9) Close the cleaning valve.

10)Movethecontrolswitchtothe"ICE"position.

11) Replace the front panel in its correct position.

12) Clean the storage bin using a neutral cleaner. Rinse thoroughly after cleaning.

13) Turn on the power supply to start the automatic icemaking process.

1 2 ... 30 31 32 33 34 35 36 37 38

Pas de commentaire

Hoshizaki KM-1900SWH/3 Manuel d'utilisateur Page 35