Hoshizaki FD-1001MRH(-C) Manuel d'utilisateur télécharger pdf (Page 41)

B. Maintenance

This icemaker must be maintained individually, referring to the instruction manual and

labels provided with the icemaker. The schedule below is a guideline. More frequent

maintenance, however, may be required depending on water quality, the icemaker's

environment, and local sanitation regulations.

Consult with your local distributor about inspection and maintenance service. To obtain

the name and phone number of your local distributor, visit www.hoshizaki.com or call

Hoshizaki Technical Support at 1-800-233-1940 in the USA.

WARNING

1. Only qualied service technicians should attempt to service or maintain this

icemaker.

2. Disconnect power before performing maintenance.

Maintenance Schedule

Frequency Area Task

Every 2

Weeks

Air Filter(s) Inspect. Wash with warm water and neutral cleaner if dirty.

Monthly External Water

Filters

Check for proper pressure and change if necessary.

Icemaker and

Dispenser Unit/

Storage Bin

Exterior

Wipe down with clean, soft cloth. Use a damp cloth containing a neutral

cleaner to wipe off oil or dirt build up. Clean any chlorine staining (rust

colored spots) using a non-abrasive cleaner like Zud or Bon Ami.

Infrared Sensor

Lens; Underside of

Icemaker and Top

Kits; Bin Door and

Snout (if applicable)

Wipe down with clean cloth and warm water.

Every 6

Months

Icemaker and

Dispenser Unit/

Storage Bin

Clean and sanitize per the cleaning and sanitizing instructions provided in

this manual.

Evaporator

Condensate Drain

Pan and Gear

Motor Drain Pan

Wipe down with clean cloth and warm water. Slowly pour one cup of

sanitizing solution (prepare as outlined in the sanitizing instructions in

this manual) into the evaporator condensate drain pan. Be careful not to

overow the pan. This solution will ow down to the gear motor drain pan

and out the drain line to sanitize these areas. Repeat with a cup of clean

water to rinse.

Icemaker and

Dispenser Unit/

Storage Bin Drains

Check to make sure they are clear.

Yearly InletWaterValve

andDrainValve

Close the water supply line shut-off valve and drain the water system.

Clean the inlet water valve screen and clean and inspect the drain valve.

Water Hoses Inspect the water hoses and clean/replace if necessary.

Condenser

(air-cooled and

remote air-cooled)

Inspect. Clean if necessary by using a brush or vacuum cleaner.

Icemaker Inspect for oil spots, loose components, fasteners, and wires.

Upper Bearing

(extruding head)

Check for wear using .02" round stock or pin gauge. Replace both upper

bearing and lower bearing if wear exceeds factory recommendations. See

the Service Manual for details.

1 2 ... 36 37 38 39 40 41 42 43 44

Commentaires sur ces manuels

Pas de commentaire

Hoshizaki FD-1001MRH(-C) Manuel d'utilisateur Page 41

Commentaires sur ces manuels

Produits connexes et manuels pour Congélateurs Hoshizaki FD-1001MRH(-C)