Hoshizaki C-101BAH-AD Manuel d'utilisateur télécharger pdf (Page 20)

9) Temporarily fasten the overlay panel to the door using 2 of the M4×25 pan head screws

provided. NOTICE! Ensure that the back surface of overlay panel is at before

attaching. See Fig. 18.

10) Mark the centerpoint of the hinge (C1) and hinge (C2) holes that extend over the

overlay panel. See Fig. 19.

11) Remove the overlay panel from the door.

7) Remove the bushings from hinge (C1) and hinge (C2) (the hinges attached to the door).

See Fig. 16.

8) Remove the gasket from the door. See Fig. 17.

Gasket

Screws

Mark the center point.

Overlay Panel

Door

Hinge

Bushing

Fig. 16

Fig. 17

12) Drill 3/8" diameter holes 1/4" (7 mm) deep where you marked on the overlay panel to

accommodate the hinge (C1) and hinge (C2) bushings.

Fig. 18 Fig. 19

Hinge

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Pas de commentaire

Hoshizaki C-101BAH-AD Manuel d'utilisateur Page 20