9
D. Setup
1. Install the Toe Kick
1) Remove the plastic lm from the toe kick.
2) Block the rollers to prevent the unit from rolling. See Fig. 2. Tilt the unit back.
NOTICE!Protect the oor. Do not tilt the unit more than 45°. Support the unit so it
does not topple over.
3) Clean the toe kick attachment area with a clean soft cloth using a mild soap to remove
any oil or dirt. Dry the toe kick attachment area thoroughly with a clean soft cloth.
4) Peel off the liner from the double-sided tape on the toe kick.
5) Attach the toe kick to the bottom of the unit.
6) Apply rm pressure along the base of the toe kick to secure it in position.
2. Install the Top Trim
To achieve a built-in look when installing in a cabinet application, the top trim can be
installed. To install the top trim, follow the directions below.
1) Remove the plastic lm from the top trim.
2) Clean the unit's top panel with a clean soft cloth using a mild soap to remove any oil or
dirt. Dry the top panel thoroughly with a clean soft cloth.
3) Peel off the liner from the double-sided tape on the top trim.
4) Attach the top trim to the top panel.
5) Apply rm pressure along the base of the trim to secure it in position.
3. Position and Level the Unit
Position the unit in its permanent location. Level the unit by adjusting the legs.
NOTICE! Do not remove the legs. The legs are necessary to maintain proper
clearance for airow.
4. Adjust the Shelves
The unit comes with 2 lower shelves and 1 upper shelf. Adjust shelf positions as needed.
Top Trim
Toe Kick
Fig. 2
Rollers
Leg
Leg
Commentaires sur ces manuels